CR300
共軌噴油試驗臺
博世10A碼生成
IQA碼能自定義修改每工況
噴油量而不需要維修噴油器
噴油器銜鐵行程升程測試
軌壓可達2600巴
連續24小時工作油溫不高于42度
設備可靠性高全年運行無故障
響應時間測試
電磁閥電阻測試
電磁閥電感測試
開啟脈寬測試
開啟壓力測試
共軌噴油器實驗臺
則試范國
可以測試電磁控制油器廠家:
博世、電裝,德爾福,西門子
卡特彼勒
| 技術參數 | |
| 供電電壓 | 220VAC/380VAC |
| 相數 | 單相/三相 |
| 頻率 | 50Hz/60Hz |
| 電流 |
30A(Max) |
| 電機功率: 油溫控制 |
5.5Kw 加熱強制冷風 |
| 油溫設定: | 40攝氏度 |
| 使用環境溫度 | 小于35攝氏度 |
| 最大共軌壓力 | 180-240Ma |
| 共軌泵 | Bosch CP3.3 |
| 控制回路電壓 | Dc24V/Dc12V |
| EcU內部升壓 | 0-200VDc(Max) |
| 測試油箱容積 | 19升 |
| 噪音水平 | <85dB |
| 重量 | 350kg |
| 外觀凈尺寸 | (高x寬x長)141x85x120cm |
| 包裝后木箱 | (高x寬x長)150x95x130cm |
CR300
Common rail injection test bench
Bosch IQA code generation
IQA code can customize each condition
Fuel injection without the need to repair the injector
Injector armature stroke lift test
Rail pressure up to 2600 bar
The working oil temperature is not higher than 42 degrees for 24 hours.
High reliability of equipment, no failure throughout the year
Response time test
Solenoid valve resistance test
Solenoid valve inductance test
Opening pulse width test
Opening pressure test
Common rail injector test bench
Test Range
Can test below control system:
Bosch, Denso, Delphi, Siemens
Caterpillar
| Technical parameters | |
| Power supply | 220VAC/380VAC |
| Phase | Single phase/ Three phase |
| Frequency | 50Hz/60Hz |
| Current | 30A(Max) |
| Motor Power | 5.5Kw |
| Oil temperature control | Heating /strong cooling wind |
| Oil temperature setting | 40 degrees Celsius |
| Use ambient temperature | less than 35 degrees Celsius |
| Maximum common rail pressure | 180-240Mpa |
| Common rail pump | Bosch CP3.3 |
| Control loop voltage | DC24V/DC12V |
| ECU internal boost | 0-200VDC(Max) |
| Test tank volume | 19L |
| Noise level | <85dB |
| Weight | 350kg |
| Net size | (L*W*H)120*85*141cm |
| Wooden package size | (L*W*H)130*95*150cm |
